|
|
|
- Pick up the external male/female plug.
- With the White wire in hand, carefully slide in the twisted copper conductors into the slot on the external plug where the silver colored screw is.
- With the screwdriver, tighten the silver screw (Refer to Figure 3).
- With the Black wire in hand, carefully slide in the twisted copper conductors into the slot on the external plug where the gold colored screw is.
- Tighten the gold screw.
- With the Green wire in hand, carefully slide in the twisted copper conductors into the slot on the external plug where the green colored screw is.
- Tighten the green screw.
- Once all screws are tightened, re-check to make sure that the Black wire is tightened with the gold screw, the White wire is tightened with silver screw, and the Green wire is tightened with the green screw (Refer to Figure 4).
- Slide the outside cover of the plug onto the plug and in the necessary slot indicated by a square located on the top of the plug and outside piece.
- Slide the inside portion of the plug into the plug, lining up the screw cylinders with the desired holes.
- Using the long screws, tighten each screw in the holes at the top of the plug.
- After the screws are tightened, take the two bottom pieces and place them in the slots at the bottom of the cord.
- Screw in the shorter screws into the holes at the bottom of the extension cord. Note: be sure the cord is gripped, but not mashed in.
Figure 3
Figure 4