Instructions for Authors

Instructions to Authors

First Author¹ and Second Author²
¹University of Louisiana at Lafayette, Lafayette, LA 70504- 1010.
²Department of Mathematical Sciences, Florida Institute of Technology, Melbourne, FL 32901-6988.
ABSTRACT: The abstract must not exceed 200 words. Begin the abstract two lines below the address.
AMS (MOS) subject classification: 34K10, 34B15, 34K25

1. INTRODUCTION
Manuscripts (one original and two copies) can be submitted to the MANAGING EDITOR or to any one of the members of the Editorial Board. Manuscript submitted to this journal has not been published previously, has not been copyrighted, is not been submitted elsewhere and the author(s) agrees that the copyright for article will be transferred to the publisher upon acceptance of the article.

International Journal of Hybrid Systems is printed by photo-offset from the master copy delivered in the camera-ready form. The manuscript should be typed in one column on white sheets of paper with dark, sharp and clear letter quality type and must remain legible after 20 percent reduction (Times 12 or similar size fonts). The title of the manuscript should be typed in bold 16 size of the same font type. Reference section should be typed in 10 or similar size font of same type face

Manuscript should be in English and typed on 8.5”11” white paper. Spacing has to be 1.25 line and left and right margins 1.3 inch each. The top margin of the first page of the article must be at least 2 inches. The subsequent pages have to be typed 9 inches deep (top margin of 1.25 inch and bottom margin of 0.75 inch). If you are using A4 size sheet, then make sure that the text size is followed according to the instructions above. Do not type page numbers. Use blue pencil to write page numbers on the back of the sheet at top right corners. Begin the names of authors two lines below the title.

2. SECTIONS AND SUBSECTIONS
2.1 Sections
         Titles of all principal SECTIONS, ACKNOWLEDGMENT, AND APPENDICES should be typed centered and capitalized bold in the same font as the manuscript. Appendices should follow REFERENCES and should be indexed (A, B,…) or enumerated (1,2,…).

2.1.1 Subsections
         Title of subsections should be typed bold left edge adjusted with the same font as the manuscript.

3. TEXT
         Paragraphs should have 0.3 inch indent. First paragraph. First paragraph in a section/subsection or after expression or Figure should be typed without indent. Type all equations. Enumerate in Arabic numerals in parenthesis flush with margin. Number display equations consecutively. All publications cited in the text should be presented in the list of references following the text of the manuscript. In the text references should be given by a number in square brackets on the line (e.g. Since Brezis and Browder [2]), and the full reference should be given in a numerical list at the end of the paper. References should be given in the following form:

[1] A. Ambrosetti, G. Prodi, A Primer of Nonlinear Analysis, Cambridge University Press, Cambridge,
    1993.
[2] H. Brezis, F. Browder, Some Properties of Higher Order Sobolev Spaces, J. Math. Pures Appl. 61
    (1982) 245-259.

         All acknowledgements for technical and financial support should go in the special section, which follows the text but precedes the references.

4. PREPARATIONS OF CAMERA READY ILLUSTRATIONS
         Proper figure preparation is essential for optimum reproduction of line drawing and photograph. Figures and Tables should be placed as part of the text and should be numbered. Reprints, if needed, should be ordered as soon as the article is accepted for publication.